View source for SCSI Hard Drive Triage

__NOTOC__
SCSI Hard Drive sorting is done in [[Advanced Test]].

== Start ==
copied from ps triage, not done yet.

We sort mostly by size & speed, 
but also serve special requests from buyers.

Follow the triage flow chart below to determine which pile to put the power supply in. You will need to test some power supplies to complete this task.

== Triage Chart ==
<graphviz>
  
  digraph POWERSUPPLYTRIAGE {
  node [fontname="Helvetica", fontsize="11"]
  edge [fontname="Helvetica"] 

  at        [label="Is it an AT?\n(not an ATX)"]
  start     [label="START HERE", shape="box", style="bold"]
  switch    [label="Does it have an\nintact SWITCH?"]
  shape     [label="Is it the same shape and size\n as the power supply marked 'EXAMPLE'?\nLittle metal rails don't count as different;\nexternal fans do."]
  compaq    [label="Does it say 'COMPAQ' on its label?"]
  broken    [label="Is it broken?\nDoes it have clipped cords or an open case?\nDid somebody write 'BAD' on it?"]
  test      [label="TEST IT\nDoes it work?"]
  inspect   [label="VISUALLY INSPECT IT\nAre there scorched connectors?"]
  keep      [label="KEEP."  shape="box", style="bold"]
  recycle   [label="RECYCLE" shape="box", style="bold"]  

  start -> at
  at -> switch [label="YES"]
  at -> shape [label="NO"]

  switch -> keep [label="YES"]
  switch -> recycle [taillabel="NO"]

  shape -> broken [label="YES"]
  shape -> recycle [taillabel="NO"]

  broken -> recycle [taillabel="YES"]
  broken -> inspect [label="NO"]

  inspect -> compaq [label="NO"]
  inspect -> recycle [label="YES"]

  compaq -> recycle [label="YES"]
  compaq -> test
  test -> recycle [label="NO"]
  test -> keep [label="YES"]
  }
</graphviz>

== Testing Power Supplies ==
Use a standard ATX power supply tester for a 20 pin ATX power supply. If you have a 24 pin ATX power supply, send it to advanced testing instead.

For each power supply that needs to be tested, do these things:

# Plug each power supply into outlet
# If there is a rear power supply switch, make sure it is turned on.
# Connect the tester to the 20 pin ATX connector
#* Check lights (all lights on is good, but it is also OK if the -5V light is off)
# Connect the tester to the 4 pin ATX connector
#* Check to see if the +12V light is on

== What to do when done, where to put them ==

; Keepers
: Mark them '''small smiley face''' in a corner on the side where the wires come out with a sharpie
: Take them to the warehouse and put them in the POWER SUPPLIES TO KEEP location
; Recycle
: Mark them '''LARGE frowny face''' somewhere with a sharpie
: Take them to the warehouse and put them in the POWER SUPPLIES TO RECYCLE location

[[Category: Advanced Test]]