Difference between revisions of "Card sorting by function"

From FreekiWiki
Jump to navigation Jump to search
Line 6: Line 6:
 
! width=150 | Type
 
! width=150 | Type
 
! width=150 | Picture
 
! width=150 | Picture
! width=150 | Note
+
! width=150 | Clue
 
|- align = "center"
 
|- align = "center"
 
| HD15  
 
| HD15  

Revision as of 14:48, 19 September 2007

Step One -- Familiarize Yourself with Connectors

First, get a box of cards to be sorted, pour them into a pile in the center of the table, and rummage through them, looking for these connector types:

Type Picture Clue
HD15 Hd15port.png three rows of holes
RJ11 Rj11port.png like for a phone
RJ45 Rj45port.png bigger than an RJ11
Sound Ports Soundports.png Little Round
antenna connector SMA.jpg small

NOTE: You're not sorting yet, just learning the different connector types.

There will be other connector types, but the above ones are all you need to pay attention to in order to complete this job.

Step Two -- The Basic Sort

Pick up each card and using the following chart, put each card in one of five piles (video, sound, modem, network, and miscellaneous.)

This is a graph with borders and nodes. Maybe there is an Imagemap used so the nodes may be linking to some Pages.

Step Three -- Subsort according to slot type

Get someone to check your work so far, and they will show you how to tell PCI, ISA, and AGP slots from all the other types of card slots. Then you can use the below charts to subsort each of the five piles into a grand total of twelve piles. (See the bold ovals below each of the five main types to do your sub-sort.)

This is a graph with borders and nodes. Maybe there is an Imagemap used so the nodes may be linking to some Pages.

This is a graph with borders and nodes. Maybe there is an Imagemap used so the nodes may be linking to some Pages.

This is a graph with borders and nodes. Maybe there is an Imagemap used so the nodes may be linking to some Pages.

This is a graph with borders and nodes. Maybe there is an Imagemap used so the nodes may be linking to some Pages.

This is a graph with borders and nodes. Maybe there is an Imagemap used so the nodes may be linking to some Pages.

(no subsort required)

This is a graph with borders and nodes. Maybe there is an Imagemap used so the nodes may be linking to some Pages.

Step Four -- Sub-sub-sort the PCI Network Cards

Take the PCI network card pile and sort it into two piles, those marked 100 or 1000 somewhere on the faceplate and those that are not. (Note some network cards are marked both 10 and 100. These should be put in the "MARKED 100 or 1000" pile.)

This is a graph with borders and nodes. Maybe there is an Imagemap used so the nodes may be linking to some Pages.

Step Five -- Finish Up

See if it's correct. You should now have up to 14 piles:

  1. Video Cards, PCI
  2. Video Cards, AGP
  3. Video Cards, OTHER
  4. Modems, PCI
  5. Modems, ISA
  6. Modems, OTHER
  7. Sound, PCI
  8. Sound, NON-PCI
  9. Network, PCI, marked 100 or 1000
  10. Network, PCI, NOT marked 100 or 1000
  11. Network, NON-PCI
  12. Wireless
  13. Miscellaneous, PCI or AGP
  14. Miscellaneous, Other

Have someone check your work and then put the cards in their boxes. (Check the box contents as you go, since someone before you might have made a mistake!) The boxes are behind you, probabley in the same order as above

Thanks for helping us sort these cards!