Difference between revisions of "External Hard Drive Testing"
Jump to navigation
Jump to search
m |
|||
Line 1: | Line 1: | ||
===How to test External Hard Drive Enclosures=== | ===How to test External Hard Drive Enclosures=== | ||
# Have the Advanced Testing staff or key holder get you the following: | # Have the Advanced Testing staff or key holder get you the following: | ||
− | :* External H.D. Testing Kit (hard drives with files on them). | + | :* External H.D. Testing Kit (hard drives <u> formatted, partitioned, & with files on them </u> ). |
:* External Hard Drives. | :* External Hard Drives. | ||
:* Power supplies. | :* Power supplies. | ||
Line 21: | Line 21: | ||
:** Place it in the Store Box. | :** Place it in the Store Box. | ||
:* If it does not show up, try mounting it in commandline if you know how. | :* If it does not show up, try mounting it in commandline if you know how. | ||
− | :** If it will not mount, | + | :** If it will not mount, throw it in the recycle bin. |
Good work, now do it again! | Good work, now do it again! | ||
[[Category: Advanced Testing]] | [[Category: Advanced Testing]] |
Revision as of 17:25, 24 July 2010
How to test External Hard Drive Enclosures
- Have the Advanced Testing staff or key holder get you the following:
- External H.D. Testing Kit (hard drives formatted, partitioned, & with files on them ).
- External Hard Drives.
- Power supplies.
- Match the power supplies with the external hard drive enclosures by looking at the connector, voltage and amps.(There may be matched hard drive enclosures in marked box from the Tartis.)
- If you can not find the appropriate power supply in the box, look in network testing.
- Plug it in and see if it gets power. If not, try switching the power supply. If that doesn't work, through it in the recycling bin.
- Open H.D. enclosure and remove hard drive.
- Immediately give to a key holder to lock in up. (If there is no-one around then put it in the incoming hard drive box in Pre-build).
- Connect IDE ribbon cable or SATA cable to Advanced Testing Hard Drive and connect usb or firewire cable to system.
- Connect Firewire Cable, Minu Firewire and or USB Cable from the External HD Testing Computer. (Can't test External Serial ATA yet).
- If it mounts and you are able to open the files on the drive it is good.
- If you don't see it on desktop go to Places-> Computer.
- Fill out "Tested By" sticker and write whether it is SATA or IDE.
- Place it in the Store Box.
- If it does not show up, try mounting it in commandline if you know how.
- If it will not mount, throw it in the recycle bin.
- If it mounts and you are able to open the files on the drive it is good.
Good work, now do it again!