Revision as of 17:05, 28 June 2007

Keeping our Forklift happy and ready to roll

Daily checklist

Weekly checklist and maintainance

Charging the Battery

Let the charge get down to or below 20%, then charge. Deep discharge before charging will prolong battery life & prevent "memory" problems.

How does the charger work? = There is no "ON" switch, just plug it into the battery, & wait about 5 seconds, you'll hear the hum. It will stop by itself.

There is a "STOP" switch if we wanna stop the charge for any reason.

Equalizing

Once a week "EQUALIZE" with the normal charge by pushing the equalize button on the charger. We try not to do this longer than overnight, overcharging can occur.

Water

Check the water level in each cell AFTER charging, & after the water has cooled a bit - like the morning after the charge. Adding tap water - with all its minerals & junk - will shorten battery life.

To charge the battery

shut down the forklift completely
open up and fold back the seat lid over the battery
unplug the huge cable from the forklift and plug it into the charger
wait 5 seconds, you'll hear a hum when charger is working
the charger will shut down by it self, reconnect big cable to battery, and fold down the seat. Please make sure the cable doesn't get pinched on the left side of the seat.

Note: charging the battery produces hydrogen gas bubbles coming out of the battery. DO NOT smoke near the battery when the seat lid is up, especially not while charging is going on.

Forklift Vendor

Norlift

Contact/Sales Kevin Hannum

cell 503 209 0987 Office 503 659 5438

@@ Line 25: / Line 25: @@
 === To charge the battery ===
 # shut down the forklift completely
-# open up and latch the seat lid over the battery
+# open up and fold back the seat lid over the battery
-# make sure the charger is off (at zero)
 # unplug the huge cable from the forklift and plug it into the charger
-# turn the charger past 6 hours and then set the charging time to the length of time that the forklift was actually used.  This can be done at the end of the day.
+# wait 5 seconds, you'll hear a hum when charger is working
-# After the charger time is up.  Unplug the battery from the charger, plug it back into the forklift, close the seat cover and your finished.
+# the charger will shut down by it self, reconnect big cable to battery, and fold down the seat. Please make sure the cable doesn't get pinched on the left side of the seat.
 '''Note: charging the battery produces hydrogen gas bubbles coming out of the battery.  DO NOT smoke near the battery when the seat lid is up, especially not while charging is going on.

Difference between revisions of "Forklift"