Difference between revisions of "Laptop Build Abbreviated Checklist"
m |
m |
||
Line 1: | Line 1: | ||
__NOTOC__ | __NOTOC__ | ||
− | + | *This is a brief guide for experienced builders. | |
− | This is a brief | + | *Reference your build binder for how-to and troubleshooting instructions. |
+ | *Thanks for all your hard work! | ||
===1. Inspect the system=== | ===1. Inspect the system=== |
Revision as of 13:49, 29 December 2012
- This is a brief guide for experienced builders.
- Reference your build binder for how-to and troubleshooting instructions.
- Thanks for all your hard work!
1. Inspect the system
☐ Replace needed parts, repair damages where possible, note cosmetic damage on the Keeper label.
2. Verify Keeper lable information
☐ Fill out the top sections of the Keeper label.
3. Check for an imaged hard drive
☐ Install a drive as needed, according to Laptop Specs (A-3).
4. Check optical drive hardware
☐ Make sure the laptop has a CD/DVD-ROM or CD/DVD-RW drive installed.
- Note the drive on the Keeper label as well.
5. Find an appropriate AC adapter
6. BIOS
☐ Set the BIOS boot order.
- Optical drive first, hard drive second, network boot last.
☐ Verify that BIOS recognizes approximately the same amount of RAM as recorded on the Keeper label.
7. Test Input Devices
☐ Use the Keyboard and Mouse testing software on the network boot menu.
- Be sure to test all trackpad inputs.
8. Boot into Xubuntu 12.04
9. Run basiccheck
and stress-test
- For audio, be sure to test both internal speakers and headphone (1/8") jack.
10. Configure networking
☐ Confirm internet access via LAN port by browsing to a website.
☐ Confirm wireless works by browsing to a website.
11. Test optical drive
☐ Verify that the optical drive can read CD and DVD media.
- Disk burning testing has been removed from laptop build for the time being.
12. Test USB ports
13. Run printme
☐ Make sure your instructor signs off on the digital copy.
☐ Print a copy of the Printme to the Desktop.
14. Next steps
☐ Set the appropriate GUI settings for batterytest
in Menu >> Settings >> Power Management.
☐ Review the Keeper label, and start any needed tests.