Power Supply Triage
Jump to navigation
Jump to search
Power supply sorting is done in System Evaluation.
Start
You will need a power supply tester and a sharpie, plus a three boxes to hold finished power supplies.
Create a temporary place for three piles:
- Keep
- Recycle
- Needs expert attention
Follow the triage flow chart below to determine which pile to put the power supply in. You will need to test some power supplies to complete this task.
Triage Chart
Is it 24 pin capable?
Testing Power Supplies
Use a standard ATX power supply tester for a 20 pin ATX power supply. If you have a 24 pin ATX power supply, send it to advanced testing instead.
For each power supply that needs to be tested, do these things:
- Plug each power supply into outlet
- If there is a rear power supply switch, make sure it is turned on.
- Connect the tester to the 20 pin ATX connector
- Check lights (all lights on is good, but it is also OK if the -5V light is off)
- Connect the tester to the 4 pin ATX connector
- Check to see if the +12V light is on
What to do when done, where to put them
- Keepers
- Mark them OK in a corner on the side where the wires come out with a sharpie.
- Use small letters. These are likely going to be sold and customers don't want them all marked up.
- Put them on the POWER SUPPLIES TO KEEP shelf
- Recycle
- Mark them LARGE frowny face somewhere with a sharpie. Go ahead and be creative if you want.
- Take them to the warehouse and put them in the POWER SUPPLIES TO RECYCLE location