Power Supply Triage

This page is being migrated to a documnent of Free Geek's Google Drive. Once the migration is done, we will post a link to the new page.

Power supply sorting is done in System Evaluation.

Triage Chart

Testing Power Supplies

Use a standard ATX power supply tester for a 20 pin ATX power supply.

For each power supply that needs to be tested, do these things:

1. Plug each power supply into outlet
2. If there is a rear power supply switch, make sure it is turned on.
3. Connect the tester to the 20 pin ATX connector
   • Check lights (all lights on is good, but it is also OK if the -5V light is off)
4. Connect the tester to the 4 pin ATX connector
   • Check to see if the +12V light is on

What to do when done, where to put them

Keepers

Mark them OK in a corner on the side where the wires come out with a sharpie.

• Use small letters. These are likely going to be sold and customers don't want them all marked up.

Put them on the POWER SUPPLIES TO KEEP shelf

Recycle

Mark them LARGE frowny face somewhere with a sharpie. Go ahead and be creative if you want.

Take them to the warehouse and put them in the POWER SUPPLIES TO RECYCLE location