Motherboard Sorting

From FreekiWiki
Revision as of 16:42, 5 July 2014 by Kevin.Williams (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

This page has been migrated to a document on Free Geek's Google Drive.

Information remaining behind may no longer be relevant.


When you have tagged this page as migrated,
please add a link to the new document on Google Drive.

(Link to new page immediately below.)


Do we want the motherboard?

This is a graph with borders and nodes. Maybe there is an Imagemap used so the nodes may be linking to some Pages.

Blown caps
Capacitors are little cylinders that stick up out of the motherboard. The tops should be flat. If they have been damaged, the tops may bulge slightly. This indicates likely failure of the motherboard. A system with blown caps might POST and seem to work fine for a while before failing mysteriously.
Risers (in this context) are portions of the motherboard that stick into the main part of the motherboard in order to provide slots for cards. Most motherboards that need risers can be distinguished by the fact that the cards are parallel to the main part of the motherboard.
DDR slots
DDRs are a type of DIMM (dual inline memory module). There are three types of DIMMs (SDRAM, DDR, and RAMBUS). These are all the same length and they all have little handles on the ends of the slot to hold the memory in place, but each types has a different number of notches in them (or different placement of the notches). DDR slots accommodate a single notch near the middle of the memory stick. (See also What kind of memory is this?
IDE Drive Connector
Rectangular connector with two rows of pins. Note the blank pin spot in the middle.


SATA (Serial ATA) Drive Connector
Small L-shaped connector usually protected by a little wall around it. This is the newest drive connector type.

Sataport.png En Español