Wireless Keyboard Testing

From FreekiWiki
Revision as of 10:50, 15 August 2014 by Kevin.Williams (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
deletion

This page has been migrated to a document on Free Geek's Google Drive.

Information remaining behind may no longer be relevant.

MIGRATOR:

When you have tagged this page as migrated,
please add a link to the new document on Google Drive.

(Link to new page immediately below.)


Link

In Progress...


STEPS NOTES AND DETAILED INSTRUCTIONS
Getting Set Up You should see the GUI applet running in the top toolbar, click on the Bluetooth symbol, and make sure that Bluetooth is on. If not, see the Troubleshooting Steps section.
Test the Device

Select System> Preferences> Bluetooth> Setup New Device> Forward

Throw some batteries in the keyboard to be tested, and switch it on (consult manufacturer manuals as needed)

The keyboard should show up in the list, select the keyboard and click Forward

Follow the on-screen instructions to enter the PIN

Test the Keyboard

Test the keyboard using wx-keyboard-tester (from the Free Geek repository). To open, (in Ubuntu 10.04) hit ALT+F2 and type wx-keyboard-tester, and hit enter. In WKT, hit Settings, and select the keyboard layout you need to test. Test each key. If any keys are not functional, gently pry up the key and clean the contact. If it still does not work, the keyboard will need to be recycled.

Remove the Device

Go back to System> Preferences> Bluetooth, select the tested keyboard from the list, and hit Remove

Finishing Steps

Add a Tested By sticker, and clean the keys.

Recycle if keyboard....
  • doesn't power on with known good batteries
  • doesn't connect after a few attempts/restarting BT service
  • is too disgusting or damaged
  • has non-functional or sticky keys



Also applies to Apple Wireless Keyboard Testing Model A1016 keyboards are very straightforward to test, I have not had good luck with newer models, but there are far fewer available to try. Lynnae 19:58, 11 July 2012 (UTC)


Troubleshooting Tips

Make sure the Indicator Applet is running in the top toolbar (right-click the toolbar, select Add to Panel> Indicator Applet)

hcitool dev

if nothing returns your bluetooth device is disabled

check

rfkill list all

hard/softblock should be no

check BIOS and make sure BT is not disabled there, check the applet in your toolbar, see if you can enable it from there, see if there is a keyboard switch (laptops only)

Restart BT daemon sudo /etc/init.d/bluetooth restart or sudo /etc/init.d/bluez-utils restart from older documentation

In general, from the research I've done, the state of Bluetooth development in the Linux world is pretty haphazard at this point. If anyone has good instructions for manually connecting devices via the command line or other CLI troubleshooting ideas, please contribute.