Difference between revisions of "User:Tonyr/Scratch"

From FreekiWiki
Jump to navigation Jump to search
(→‎iMac Rebuild Table: add some more detail)
m (proposed update with DDR2/3 images)
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
==iMac Rebuild Table==
+
'''OBJECTIVE'''   To enable the builder to recognize and install memory sticks on the motherboard
{| border="1"
 
|-
 
|width="300pt" align="center"|Steps
 
|width="400pt" align="center"|Notes
 
|width="50pt"  align="center"|Done
 
|-
 
| Remove bottom cover ||
 
#Flip iMac over on a soft mat
 
#Remove 4 screws (#2 Phillips):
 
#*2 near hinged front lifter
 
#*2 underneath oval grill (which can be gently pried open with a flat tip screwdriver), the 2 outermost screws
 
#gently lift rear of cover; if there is resistance from the front, strike front of cover gently but firmly with heel of hand to release the latches 
 
||
 
|-
 
| Remove metal mesh cover plate ||
 
*Use a magnetized #2 Phillips screwdriver, otherwise run the risk of dropping a screw into the interior of the iMac.
 
*Remove the 6 #2 Phillips screws holdoing the plate:
 
**4 around the outer edge
 
**2 on top
 
||
 
|-
 
| Check capacitors ||  ||
 
|-
 
| Remove ram || Put ram in Eval DIMM box or Advanced Test Incoming box ||
 
|-
 
| Remove hard drive ||
 
#Disconnect power connector and ribbon cable
 
#Remove 4 #1 or #2 Phillips screws on top of drive cage
 
#Slide drive out
 
#Put hard drive in Eval hard drive bin
 
||
 
|-
 
| Test battery ||
 
#Remove battery
 
#Test for 3.6v or better
 
#Replace with good battery if less than 3.6v
 
#Reinstall
 
||
 
|-
 
| Replace ram || 256MB, 2x128MB PC-100 SDRAM  ||
 
|-
 
| Replace hard drive || 20GB ||
 
|-
 
| Clean/dust inside || If necessary || 
 
|-
 
| Attach keyboard/mouse and powercord || Leave iMac upside down  ||
 
|-
 
| Power on, boot Finnix CD  ||
 
#Press power button
 
#Immediately insert Finnix CD
 
#At the chime, press C key and hold until small underline cursor appears in upper left corner of display
 
||
 
|-
 
| Record configuration ||
 
*CPU type and speed, memory size, HD size, video controller, CD/DVD type: 
 
**Finnix boot message shows CPU speed and detected memory size
 
**HD size is known from installation
 
**Command to list the video controller:
 
***'''lspci'''  
 
**Command to show CD/DVD model name:
 
***'''cat /proc/ide/hdb/model'''
 
  
||
+
RAM (or Random Access Memory) is an important part of the computer system which is used by actively running programs to perform necessary tasks while the computer is on. It is composed of integrated circuit memory chips that allow information to be stored or accessed in any order and all storage locations are equally accessible. The information on RAM can be tossed out to make more space, as opposed to the Hard Disk Drive where the computer stores information for the long haul.
|-
 
| Set HW date/time to UTC ||
 
*Set system clock with command
 
**'''date -u MMDDhhmmYYYY'''
 
***'''MM''' month, '''DD''' day, '''hh''' hour, '''mm''' minute, '''YYYY''' year
 
***hour and minute are GMT(UTC) time in 24 hour clock format; GMT time is local (Pacific) time plus 7 hours (summer,PDT) or 8 hours (winter, PST)
 
*Set CMOS clock from system clock
 
**'''clock -uw'''
 
  ||
 
|-
 
| Power down || Use command:
 
*'''shutdown -h now'''
 
CD will be ejected automatically;
 
||
 
|-
 
| Disconnect powercord, keyboard cable ||  ||
 
|-
 
| Replace bottom covers ||
 
*Replace metal mesh cover plate; remember to use magnetized screwdriver
 
*Replace bottom cover
 
**Seat front first
 
**Make sure cover is seated flush all around
 
*Flip iMac right side up
 
||
 
|-
 
| Reconnect powercord, keyboard cable, network cable ||  ||
 
|-
 
| Install Ubuntu ||
 
# Push power button
 
# Simultaneously press keys '''Option+Apple+O+F'''
 
# When OpenFirmware prompt appears, type
 
#* '''boot enet:0,yaboot'''
 
#Respond with Enter key to all questions except these:
 
## Automatically detect keyboard: '''No'''
 
## Machine name: '''ubuntu'''
 
## Time zone: '''Pacific'''
 
##* Scroll down to '''Pacific''' with down-arrow key
 
##* Press Enter
 
## Full user name: '''oem'''
 
## User login name '''oem'''
 
## User password: '''freegeek'''
 
## Verify user password: '''freegeek'''
 
## Write partition information to disk: '''Yes'''
 
## Additional software: '''Ubuntu Desktop'''
 
##* Scroll down to '''Ubuntu Desktop''' item with down-arrow key
 
##* Press space bar to select the item; an asterisk character appears in the brackets
 
##* Press Enter
 
# When installation is complete, press Enter at final question and the computer will reboot automatically.
 
  ||
 
|-
 
| Install extra apps, as necessary ||
 
* Use System->Administration->Synaptic Package Manager
 
* Select package '''gnome-ppp'''
 
* If the machine has a DVD drive, select package '''ogle-gui'''
 
* If the machine has a CD-RW or DVD-RW drive, select package '''k3b'''
 
||
 
|-
 
| Add Terminal and Gnome-PPP icons to top menu bar ||
 
*Select Applications->Accessories and drag Terminal icon to menu bar
 
*Select Applications->Internet and drag Gnome-PPP icon to menu bar
 
  ||
 
|-
 
| Test/detect modem ||
 
*Select Gnome-PPP icon from top menu bar
 
*In the Gnome-PPP window, select '''Setup''', then select '''Detect'''
 
*Device should change to /dev/ttyS0; speed should change to 230400
 
  ||
 
|-
 
| Test CD/DVD data and sound, and video if necessary  || TBD ||
 
|-
 
| Clean outside cover  ||  case, monitor face, connector panel, keyboard, mouse  ||
 
|-
 
| Fill out and attach store tag ||  ||
 
|-
 
| Bundle iMac with tested keyboard/mouse and power cord ||  ||
 
|-
 
| Take it to store or store staging shelf ||  ||
 
|}
 
  
==Ubuntu Installation==
+
==Memory sticks==
{| border="1"
+
:RAM or Random Access Memory comes in 2 types, DIMM and SIMM
|-
 
|width="300pt" align="center"|Steps
 
|width="400pt" align="center"|Notes
 
|width="50pt"  align="center"|Done
 
|-
 
| Attach keyboard/mouse, network cable, power cord ||  ||
 
|-
 
| Power on, perform network boot || At boot chime, press and hold Option+Apple+O+F; at OpenFirmware prompt, enter '''boot enet:0,yaboot''', then press Enter. ||
 
|-
 
|}
 
  
[[Category:Macintosh]]
+
: DIMM (Dual In-Line Memory Module)
 +
:* DIMMs are usually 5.25" long and plug into slots that have plastics clips at the end that open and close to hold them in.  There is also a type of DIMM that is only 2.5-2.75" long known as SODimm which is used in laptops and small computer systems
 +
 
 +
: SIMM (Single In-Line Memory Module)
 +
:* SIMM is the oldest form of memory that we still see and is shorter than the currently-used types - generally 4.25" long or 3.5" long.  Its slots on the motherboard have metal clamps at the end to hold the stick in place.
 +
 
 +
'''Exercise'''
 +
Find the SIMM and DIMM slots on the motherboards on the example board in front of you so you can identify these slots.
 +
 
 +
=== DDR ===
 +
[[Image:DDR.jpg]]
 +
 
 +
A stick of DDR has a single notch in it near the center of the stick.<br>
 +
''Un módulo de DDR tiene una muesca en en el centro del módulo.''
 +
 
 +
The newer DDR2 has a single notch that is slightly nearer the center of the stick, so it will not fit into a regular DDR slot
 +
[[Image:DDR2.jpg]]
 +
 
 +
And the DDR3 stick also has a single notch on it that is slightly closer to the end than the DDR. 
 +
[[Image:DDR3.jpg]]
 +
 
 +
=== RAMBUS ===
 +
[[Image:RAMBUS.jpg]]
 +
 
 +
A stick of RAMBUS has two notches in it at the center of the stick.<br>
 +
''Un módulo de RAMBUS tiene dos muescas en en el centro del palo.'
 +
 
 +
=== SDRAM ===
 +
[[Image:SDRAM.jpg]]
 +
 
 +
A stick of SDRAM has two notches in it, one near the center of the stick, and one closer to the side.<br>
 +
''Un módulo de SDRAM tiene dos muescas, una cerca del centro del módulo, y otra cerca a un extremo del módulo.''
 +
 
 +
=== 72-Pin SIMM ===
 +
 
 +
      [[Image:72-pin-simm.png]]
 +
 
 +
72 pin SIMMs are 4.25 inches long.  The holes and notches need to match exactly since there are other objects that look like 72-pin SIMM but aren't, so see points A (side holes), B (center notch) and C (side notch) in the picture.
 +
 
 +
=== 30-Pin SIMM ===
 +
 
 +
30 Pin SIMM
 +
[[Image:30-pin-simm.png]]
 +
 
 +
30-pin SIMMs are 3.5 inches long.  These are the oldest types of memory we still see on a regular basis in System Evaluation.  Note that they do not have a center notch.
 +
 
 +
 
 +
'''Exercise 1:'''
 +
Look at the example memory sticks and match them up with the following pictures and descriptions.  Then,
 +
 
 +
'''Exercise 2:'''
 +
Try putting the sticks into their slots on the motherboard.  Open the clips, match up the notches and install the stick into the grooves at either end.  Press down on the stick until the clips flip closed by themselves around the stick.  This tells you that the memory is properly seated into the slot so it can function correctly.  '''IMPORTANT - YOU CAN RUIN THE RAM AND FRY THE MOTHERBOARD IF YOU DON'T DO THIS!!!'''
 +
   
 +
 
 +
[[Category: Hardware ID]]

Latest revision as of 16:14, 8 October 2012

OBJECTIVE To enable the builder to recognize and install memory sticks on the motherboard

RAM (or Random Access Memory) is an important part of the computer system which is used by actively running programs to perform necessary tasks while the computer is on. It is composed of integrated circuit memory chips that allow information to be stored or accessed in any order and all storage locations are equally accessible. The information on RAM can be tossed out to make more space, as opposed to the Hard Disk Drive where the computer stores information for the long haul.

Memory sticks

RAM or Random Access Memory comes in 2 types, DIMM and SIMM
DIMM (Dual In-Line Memory Module)
  • DIMMs are usually 5.25" long and plug into slots that have plastics clips at the end that open and close to hold them in. There is also a type of DIMM that is only 2.5-2.75" long known as SODimm which is used in laptops and small computer systems
SIMM (Single In-Line Memory Module)
  • SIMM is the oldest form of memory that we still see and is shorter than the currently-used types - generally 4.25" long or 3.5" long. Its slots on the motherboard have metal clamps at the end to hold the stick in place.

Exercise Find the SIMM and DIMM slots on the motherboards on the example board in front of you so you can identify these slots.

DDR

DDR.jpg

A stick of DDR has a single notch in it near the center of the stick.
Un módulo de DDR tiene una muesca en en el centro del módulo.

The newer DDR2 has a single notch that is slightly nearer the center of the stick, so it will not fit into a regular DDR slot DDR2.jpg

And the DDR3 stick also has a single notch on it that is slightly closer to the end than the DDR. DDR3.jpg

RAMBUS

RAMBUS.jpg

A stick of RAMBUS has two notches in it at the center of the stick.
Un módulo de RAMBUS tiene dos muescas en en el centro del palo.'

SDRAM

SDRAM.jpg

A stick of SDRAM has two notches in it, one near the center of the stick, and one closer to the side.
Un módulo de SDRAM tiene dos muescas, una cerca del centro del módulo, y otra cerca a un extremo del módulo.

72-Pin SIMM

     72-pin-simm.png

72 pin SIMMs are 4.25 inches long. The holes and notches need to match exactly since there are other objects that look like 72-pin SIMM but aren't, so see points A (side holes), B (center notch) and C (side notch) in the picture.

30-Pin SIMM

30 Pin SIMM 30-pin-simm.png

30-pin SIMMs are 3.5 inches long. These are the oldest types of memory we still see on a regular basis in System Evaluation. Note that they do not have a center notch.


Exercise 1: Look at the example memory sticks and match them up with the following pictures and descriptions. Then,

Exercise 2: Try putting the sticks into their slots on the motherboard. Open the clips, match up the notches and install the stick into the grooves at either end. Press down on the stick until the clips flip closed by themselves around the stick. This tells you that the memory is properly seated into the slot so it can function correctly. IMPORTANT - YOU CAN RUIN THE RAM AND FRY THE MOTHERBOARD IF YOU DON'T DO THIS!!!