System Evaluation Overview

This page has been migrated to a document on Free Geek's Google Drive.

Information remaining behind may no longer be relevant.

MIGRATOR:

When you have tagged this page as migrated,
please add a link to the new document on Google Drive.

(Link to new page immediately below.)

MAIN Chart

Count the DDR slots and circle the correct number.
For AMD chips:
- Circle AMD in the "Proc Type" section
- Write the processor model number in the "Processor Information" area
For Intel and other chips:
- Circle the processor type (or write next to "Other")
- Write the processor speed in the "Processor Information" area
If there are any SATA connectors on the motherboard circle the appropriate number
- Keep in mind that SATA ports my be directed parallel to the motherboard.
If there are any IDE connectors on the motherboard circle the appropriate number
- Make sure not to count Floppy counters as IDE connectors. IDE connectors have 40 pins and pin missing in the middle. Floppy have 34-pins and 1-2 pins missing near the end.
If the system has a dual core processor, check the Dual Core box
If the system did not POST successfully, check the Did not POST box
If there are any PCIe slots, circle PCI-e
If there is an AGP slot, circle AGP
If there is an on-board video connector, circle OnBoard
Remember to put your initials in the appropriate box

NOTE: If a system has no brand name on it, then it is not on this incompatibles list.

High Speed or Ultra Speed CD RW
- They must have a standard 5.25" rectangular faceplate and not be laptop-sized.
- A drive is only High Speed or Ultra Speed if it literally says "High Speed" or "Ultra Speed" to the right of the "Compact Disc" label.

DVD Drive
- They must have a standard 5.25" rectangular faceplate and not be laptop-sized.
Front side card readers, only if it includes a cable