Difference between revisions of "Front Panel Motherboard Pin-outs"
Dunstvangeet (talk | contribs) |
Dunstvangeet (talk | contribs) |
||
| Line 17: | Line 17: | ||
IEEE usually looks exactly the same as the USB on the inside. Look for writing on the Motherboard to indicate whether it is USB or Firewire. | IEEE usually looks exactly the same as the USB on the inside. Look for writing on the Motherboard to indicate whether it is USB or Firewire. | ||
| − | {| | + | {| border=1 |
| width=80 align=center | TPA- || width=80 align=center | GND || width=80 align=center | TPB- || width=80 align=center | +12V || width=80 align=center | S-Ground | | width=80 align=center | TPA- || width=80 align=center | GND || width=80 align=center | TPB- || width=80 align=center | +12V || width=80 align=center | S-Ground | ||
|- | |- | ||
Revision as of 17:37, 30 September 2009
These are pinout settings for the standard Front Panel on Motherboards.
USB Internal
USB is made up of two 4-pin connectors, with a 5th throw away pin to make sure you don't plug it in backwards. The Pin-out information is the following:
| VCC 1 | Data- 1 | Data+ 1 | Ground 1 | Not Used |
| 2 | 4 | 6 | 8 | 10 |
| 1 | 3 | 5 | 7 | |
| VCC 2 | Data- 2 | Data+ 2 | Ground 2 | Key |
IEEE 1394 (Firewire) Internal
IEEE usually looks exactly the same as the USB on the inside. Look for writing on the Motherboard to indicate whether it is USB or Firewire.
| TPA- | GND | TPB- | +12V | S-Ground |
| 2 | 4 | 6 | 8 | 10 |
| 1 | 3 | 5 | 7 | |
| TPA+ | GND | TPB+ | +12V | Key |
Front Panel Audio
The front panel audio usually comes in either a 10-pin or a 14-pin Connection. Either way, most of them are hooked up the same way. If there is no front panel audio on the chassis, There must be jumpers between 5 and 6, and 9 and 10, or the back audio may not work.
| AUD Ground | AUD Ground | FP RET R | Key | FP RET L |
| 2 | 4 | 6 | 10 | |
| 1 | 3 | 5 | 7 | 9 |
| Mic In | Mic Power | FP OUT R | AUD +5V | FP OUT L |
Standard Front Panel Power
Front Panel Power can come in all sorts of ways. Best way is to look on the board. However, on some boards, there are is no writing. In that case, first try this output. (Note: this is a work in progress and is not correct yet.
| 2 | 4 | 6 | 8 | 10 |
| 1 | 3 | 5 | 7 | |